Celebrating 50+ Years In Craftsmanship | Est. 1975
Celebrating 50+ Years In Craftsmanship | Est. 1975
Skip to content

Powermatic Dovetail Machines

Powermatic dovetail machines are built for clean, repeatable joinery in drawer and cabinet work.

Choose your Powermatic Dovetail Machine

  • Save $ 1,534.72
    Powermatic Powermatic DT45 Dovetail Machine
    $ 8,243.72
    $ 6,709.00

    Powermatic DT45 Dovetail Machine Are you struggling to produce consistent dovetail joints with time-consuming setups and uneven results across...

    View full details
  • Save $ 2,138.07
    Powermatic Powermatic DT65 Pneumatic Dovetail Machine
    $ 11,487.07
    $ 9,349.00

    Powermatic DT65 Pneumatic Dovetail Machine Are you spending too much time manually clamping stock when producing dovetail joints? What if you cou...

    View full details

Choosing a Powermatic Dovetail Machine for Your Shop

The key difference between these two models is clamping method and production pace. Use the guide below to match each machine to your shop and workload.

Powermatic DT45 Dovetail Machine

  • Cutter height: 3/16" to 3/4"
  • Centerlines: 1", 1-1/2", 2", 2-1/2"
  • Clamping: Manual eccentric

A strong floor-standing single-end dovetailer for shops that need adjustable cutter height and consistent joint spacing without pneumatic complexity.

Powermatic DT65 Pneumatic Dovetail Machine

  • Cutter height: 3/16" to 3/4"
  • Centerlines: 1", 1-1/2", 2", 2-1/2"
  • Clamping: Pneumatic

Built for shops that run higher dovetail volumes and want pneumatic clamping to speed up workholding and keep cycling time down.


Powermatic Dovetail Machines FAQs

What is the difference between the DT45 and the DT65?

The main difference is clamping. The Powermatic DT45 uses a manual eccentric clamp, while the Powermatic DT65 uses pneumatic clamping for faster work holding. Both cut the same dovetail centerlines and cutter height range.

What cutter height range do Powermatic dovetail machines support?

Both the DT45 and DT65 adjust from 3/16" to 3/4", covering most drawer and furniture stock thicknesses.

How many dovetail centerlines do these machines support?

Both machines offer four fixed centerlines at 1", 1-1/2", 2", and 2-1/2". Fixed positions make it easy to return to the same spacing without re-measuring between setups.

Are Powermatic dovetail machines suitable for production work?

The DT45 handles consistent shop and small-batch work well. The DT65 is the better fit for higher-volume production, where pneumatic clamping reduces setup time between cuts.