Baileigh PH-19 110V Reciprocating Power Hammer
Are you looking for a reciprocating hammer that handles deep panel work without needing special wiring or a dedicated circuit?
What if your shop had a power hammer that runs on standard 110V power and lets you start shaping in the middle of a panel without clamping to an edge first?
Meet the Baileigh PH-19 110V Reciprocating Power Hammer, a plate steel frame hammer built for automotive and fabrication shaping work.
With a 19-inch throat, 1,700 beats per minute, and a quick-release tooling handle, the PH-19 covers shrinking, stretching, planishing, and more from a single machine.
When the tooling changes in seconds and the frame holds steady under load, you can focus on shaping the metal with confidence.
Baileigh PH-19 for Automotive and Fabrication Panel Work
Heavy Plate Steel Frame Holds Steady Under Load
The PH-19 is built on a half-inch plate steel frame with a rigid steel stand that resists flex during use. A stable frame keeps the tooling contact consistent so your results stay repeatable across a full panel.
19-Inch Throat Reaches Deep Panel Sections
The 19-inch throat depth gives you access to the center of large automotive panels and fabrication parts without repositioning the work. That reach is what separates this machine from smaller benchtop hammers in real panel work.
Quick-Release Tooling Handle Speeds Die Changes
The quick-release handle lets you swap tooling in seconds without hand tools, and allows work to start in the middle of a panel rather than only at an edge. A wide range of shrink, stretch, planish, and shaping dies is available to extend what the machine can do.
110V Power Runs on Standard Shop Wiring
The PH-19 plugs into a standard 110V outlet and runs at a fixed 1,700 beats per minute. No special wiring or phase conversion is needed, which makes installation straightforward in most shop setups.
What's Included
What's Included? Baileigh PH-19 110V Reciprocating Power Hammer
-
Baileigh PH-19 110V Reciprocating Power Hammer — Provides a stable plate steel frame hammer platform for automotive and fabrication panel shaping work.
-
Thumbnail Shrinker Die — Allows you to begin shrinking metal panels right out of the box.
Specs
Baileigh PH-19 110V Reciprocating Power Hammer Specifications
- Model: PH-19
- SKU: BA9-MDL-PH19
- Throat Depth: 19 in
- Beats Per Minute: 1,700
- Input Power: 110V
- Mild Steel Capacity: 16 gauge
- Aluminum Capacity: 12 gauge
- Frame: 1/2 in plate steel
- Net Weight: 715 lb
- Warranty: 1 Year parts, lifetime technical support
